Menu
Cart 0

Roses in Potatoes

Posted by Krishna Karthik on

1) In the garden, which gets some shade during the hottest part of the day, dig a trench that has one vertical side. It should be around 6in (15cm) deep; place an inch or two of sharp sand in the bottom.

2) Choose a stem – about the thickness of a pencil – from the rose you wish to propagate. The wood should be straight, ripe (tell by being able to break a thorn off cleanly) and young (from this year’s growth).

3) The cutting should be about 9in (23cm) long. Cut just below a bud at the base. Then remove the leaves and thorns from the bottom half. You can leave a couple of leaf systems at the top of the cutting if you wish.

4) Insert each cutting so that it is two-thirds buried, making sure that its base is well into the sharp sand. Firm the sand around the base, to exclude as much air as possible. Cuttings should be set about 6in (15cm) apart.

5) Add Organic Potting Mix  into the trench and firm it in place; don’t damage the cuttings as you do this. Keep the cuttings watered.

The secret of success here is the humble potato! Before planting cuttings, push the bottom end into a small potato to keep the the cuttings moist as they develop roots.


Share this post



← Older Post Newer Post →


Leave a comment

Please note, comments must be approved before they are published.